#Okidata microline 320 turbo top of form software

Adjust the paper so the first line of print aligns with the Red Line located on the Clear Plastic Ribbon Protector. Press FORM FEED to move the paper up or LINE FEED to move the paper down. If its set for anything other than 'OFF'(1 or 2 seconds) then it is considered 'ON'. Press and hold the SHIFT and LF buttons until the paper stops moving. Load a blank piece of paper into the printer. Resets the Top of Form to original settings and resets printer to factory settings. Locate the 'FORMS TEAR OFF' setting in the printed menu and take note of its setting. Turn the Printer off, then hold down the SEL and QUIET buttons as you turn on the printer. Press SEL (The SEL light Should go out)ДҐ. To do this you must print the menu as described below.Дў. IF you must use it for removing paper jams be sure the power to printer is off.Д¬hecking to see if Forms Tear off is 'ON' or 'OFF'.Д«efore setting the Top of Form you need to verify what the Forms Tear Off is set for. Doing this will always change the TOF setting. Note2 - DO NOT TURN PLATEN KNOB ON RIGHT HAND SIDE OF PRINTER.

You may need to use the instructions below to Re-adjust according to your software's needs.

#Okidata microline 320 turbo top of form software

Note1 - Your software may be printing the first line of print above or below where TOF is set. A) Press the FF/LOADButton to move the paper up, or. The factory default setting for the Top of Form (where the printing should begin) is one inch down from the top of the page. 2) Press the SELButton To Turn off the SEL Light (Deselect) 3) Press the SHIFTButton keeping it pressed. 1) Load In A Form or Paper into the Printer. 4 Keep holding SHIFT and press QUIET/TOF a few times to set the Top of Form. THESE INSTRUCTIONS WILL PERMANENTLY ALTER THE TOP OF FORM SETTING. The first line prints at the red line of the plastic paper shield (7) on the printhead. All the information provided is subject to change from time to time at the sole discretion of Oki Data.

Press FF/LOAD / Micro Feed Up to increase the space (move Top of Form lower). For information on setting the Top of Form, refer to 'Using Your Printer, Top of Form, Setting Top of Form, Forms Tear-Off (ON or OFF).'.

Okidata Microline 184 Turbo Parallel Printer Standard Emulation. Okidata Microline 320 Turbo Printer Parallel/USB (62411601) Old. It needs to be set when the first line of print does not print in the desired location. Press LF / Micro Feed Down to decrease the space (move Top of Form higher). Okidata Microline 321 Turbo Printer (62411701) USB H0. Top of Form(TOF) is the position on the paper where the first line of print will occur.